DTC P0335/13 Crankshaft Position Sensor "A" Circuit |
DTC P0339/13 Crankshaft Position Sensor "A" Circuit Intermittent |
| DTC No. | DTC Detection Conditions | Trouble Areas |
| P0335/13 |
|
|
| P0339/13 |
|
|

| Items | Contents |
| Terminals | CH1: G2 - NE- CH2: NE+ - NE- |
| Equipment Settings | 5 V/Division, 20 ms/Division |
| Conditions | Cranking or idling |

| 1.INSPECT CRANKSHAFT POSITION SENSOR (RESISTANCE) |
![]() |
Disconnect the D17 Crankshaft Position (CKP) sensor connector.
Measure the resistance between terminals 1 and 2.
| Tester Connections | Specified Conditions |
| 1 - 2 | 1,630 to 2,740 Ω at cold |
| 1 - 2 | 2,065 to 3,225 Ω at hot |
Reconnect the CKP sensor connector.
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (CRANKSHAFT POSITION SENSOR - ECM) |
![]() |
Disconnect the D17 CKP sensor connector.
Disconnect the D1 ECM connector.
Measure the resistance.
| Tester Connections | Specified Conditions |
| NE+ (D17-1) - NE+ (D1-27) | Below 1 Ω |
| NE- (D17-2) - NE- (D1-34) | Below 1 Ω |
| Tester Connections | Specified Conditions |
| NE+ (D17-1) or NE+ (D1-27) - Body ground | 10 kΩ or higher |
| NE- (D17-2) or NE- (D1-34) - Body ground | 10 kΩ or higher |
Reconnect the ECM connector.
Reconnect the CKP sensor connector.
|
| ||||
| OK | |
| 3.CHECK SENSOR INSTALLATION (CRANKSHAFT POSITION SENSOR) |
![]() |
Check the CKP sensor installation condition.
|
| ||||
| OK | |
| 4.CHECK CRANKSHAFT POSITION SENSOR PLATE (TEETH OF SENSOR PLATE) |
Check the teeth of the sensor plate.
|
| ||||
| OK | ||
| ||