DTC P2118/89 Throttle Actuator Control Motor Current Range / Performance |

| DTC No. | DTC Detection Conditions | Trouble Areas |
| P2118/89 | Open in Electronic Throttle Control System (ETCS) power source (+BM) circuit (1 trip detection logic) |
|

| 1.CHECK ETCS FUSE |
![]() |
Remove the ETCS fuse from the engine room R/B No.2.
Measure the ETCS fuse resistance.
Reinstall the ETCS fuse.
|
| ||||
| OK | |
| 2.INSPECT ECM (+BM VOLTAGE) |
![]() |
Measure the voltage between the terminals of the ECM connectors.
| Tester Connections | Specified Conditions |
| +BM (B9-7) - E1 (D1-3) | 9 to 14 V |
|
| ||||
| OK | ||
| ||
| 3.CHECK HARNESS AND CONNECTOR (ECM - ETCS FUSE, ETCS FUSE - BATTERY) |
![]() |
Check the harness and connector between the ETCS fuse and ECM.
Remove the ETCS fuse from the engine room R/B No.2.
Disconnect the B9 ECM connector.
Measure the resistance.
| Tester Connections | Specified Conditions |
| ETCS fuse (2) - +BM (B9-7) | Below 1 Ω |
| Tester Connections | Specified Conditions |
| ETCS fuse (2) or +BM (B9-7) - Body ground | 10 kΩ or higher |
Reinstall the ETCS fuse.
Reconnect the ECM connector.
Check the harness and connector between the ETCS fuse and positive battery cable.
Remove the ETCS fuse from the engine room R/B No.2.
Disconnect the positive battery cable.
Measure the resistance.
| Tester Connections | Specified Conditions |
| Positive battery cable - ETCS fuse (1) | Below 1 Ω |
| Tester Connections | Specified Conditions |
| Positive battery cable or ETCS fuse (1) - Body ground | 10 kΩ or higher |
Reinstall the ETCS fuse.
Reconnect the positive battery cable.
|
| ||||
| OK | ||
| ||