SFI SYSTEM (w/o Secondary Air Injection System) > CHECK MODE PROCEDURE |
| CHECK MODE PROCEDURE |
![]() |
Check and ensure the following conditions:
Battery voltage 11 V or more
Throttle valve fully closed
Transmission in the P or N position
A/C OFF
Turn the ignition switch to OFF.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to the ON position and turn the intelligent tester ON.
Select the following menu items: Powertrain / Engine and ECT / Utility / Check Mode.
Make sure that the MIL flashes as shown in the illustration.
Start the engine. (Make sure the MIL goes off).
Simulate the conditions of the malfunction described by the customer.
Check DTCs and freeze frame data using the tester.
After checking the DTCs, inspect the applicable circuits (Click here).