Home › BODY › SEAT › REAR NO. 1 SEAT ASSEMBLY (for Hold Down Seat Type)

REAR NO. 1 SEAT ASSEMBLY (for Hold Down Seat Type) > REMOVAL

for Preparation Click here



1. REMOVE REAR NO.1 SEAT ASSEMBLY


    B113604
  1. Disengage the claw and disconnect the cover.

    HINT:
    Use the same procedures for the RH side and LH side.



    B113605E01
  1. Remove the 2 bolts.

  1. Pull the lever in the direction indicated by the arrow in the illustration, release the 2 locks, and remove the rear No.1 seat assembly.