Home › BODY ELECTRICAL › DOOR LOCK › POWER DOOR LOCK CONTROL SYSTEM

POWER DOOR LOCK CONTROL SYSTEM > Driver Side Door UNLOCK Detection Switch Circuit

for Preparation Click here


DESCRIPTION

The door unlock detection switch is built in the door lock assembly.
This switch turns on when the door lock knob is in the unlock position and turns off when it is in the lock position. It is used as one of the operating conditions for the key confinement prevention function.

WIRING DIAGRAM


B111179E01


INSPECTION PROCEDURE

1.INSPECT FRONT DOOR LOCK ASSEMBLY (DOOR UNLOCK DETECTION SWITCH)


    B111190E01
  1. LHD Models:
    Inspect the front door lock assembly.

    1. Measure the resistance when the switch is operated according to the value(s) in the table below.

      Standard resistance:
      Tester Connection
      Door Lock Condition
      Specified Condition
      Battery positive (+) → Terminal 1
      Battery negative (-) → Terminal 4
      ON (Door lock set to UNLOCK)
      7 - 8 (Below 1 Ω)
      Battery positive (+) → Terminal 4
      Battery negative (-) → Terminal 1
      OFF (Door lock set to LOCK)
      7 - 8 (10 kΩ or higher)



    B111184E01
  1. RHD Models:
    Inspect the front door lock assembly.

    1. Measure the resistance when the switch is operated according to the value(s) in the table below.

      Standard resistance:
      Tester Connection
      Door Lock Condition
      Specified Condition
      Battery positive (+) → Terminal 1
      Battery negative (-) → Terminal 4
      ON (Door lock set to UNLOCK)
      7 - 8 (Below 1 Ω)
      Battery positive (+) → Terminal 4
      Battery negative (-) → Terminal 1
      OFF (Door lock set to LOCK)
      7 - 8 (10 kΩ or higher)



NG
REPLACE FRONT DOOR LOCK ASSEMBLY
OK


2.CHECK WIRE HARNESS (FRONT DOOR LOCK ASSEMBLY - INSTRUMENT PANEL J/B)


    E105251E01
  1. Disconnect the L1 (K1) connector.

  1. Disconnect the instrument panel J/B connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    LHD Models:
    Tester Connection
    Condition
    Specified Condition
    H7-20 - L1-8
    Always
    Below 1 Ω
    L1-7 - Body ground
    Always
    Below 1 Ω
    RHD Models:
    Tester Connection
    Condition
    Specified Condition
    H7-20 - K1-7
    Always
    Below 1 Ω
    K1-8 - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE