POWER DOOR LOCK CONTROL SYSTEM > Front Passenger Side Door Lock Motor Circuit |

| 1.INSPECT FRONT DOOR LOCK ASSEMBLY (FRONT PASSENGER SIDE) |
![]() |
LHD Models:
Inspect the front door lock assembly.
Apply battery voltage and check operation of the door lock motor.
| Measurement Condition | Specified Condition |
| Battery positive (+) → Terminal 4 Battery negative (-) → Terminal 1 | Lock |
| Battery positive (+) → Terminal 1 Battery negative (-) → Terminal 4 | Unlock |
![]() |
RHD Models:
Inspect the front door lock assembly.
Apply battery voltage and check operation of the door lock motor.
| Measurement Condition | Specified Condition |
| Battery positive (+) → Terminal 4 Battery negative (-) → Terminal 1 | Lock |
| Battery positive (+) → Terminal 1 Battery negative (-) → Terminal 4 | Unlock |
|
| ||||
| OK | |
| 2.CHECK WIRE HARNESS (FRONT DOOR LOCK ASSEMBLY - INSTRUMENT PANEL J/B) |
![]() |
Disconnect the K1 (L1) connector.
Disconnect the instrument panel J/B connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 5B-33 - K1-4 (ACT+) | Always | Below 1 Ω |
| 5B-34 - K1-1 (ACT-) | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
| 5B-33 - L1-4 (ACT+) | Always | Below 1 Ω |
| 5B-34 - L1-1 (ACT-) | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||