Home › STEERING › POWER STEERING › VANE PUMP (for 2KD-FTV)

VANE PUMP (for 2KD-FTV) > INSTALLATION

for Preparation Click here



1. INSTALL VANE PUMP ASSEMBLY
  1. Install a new vane pump O-ring to the vane pump assembly.



    C101372E01
  1. Install the vane pump assembly with the 2 nuts.

    Torque:
    39 N*m{ 398 kgf*cm , 29 ft.*lbf }

    NOTICE:
    Make sure that the vane pump O-ring is not caught between other parts.



2. CONNECT PRESSURE FEED TUBE ASSEMBLY
  1. Install a new gasket to the pressure feed tube assembly.



    C101371E01
  1. Connect the pressure feed tube assembly to the vane pump assembly with the union bolt.

    Torque:
    50 N*m{ 510 kgf*cm , 37 ft.*lbf }

    HINT:
    Make sure the stopper of the pressure feed tube assembly contacts the vane pump assembly as shown in the illustration.



3. CONNECT OIL RESERVOIR TO PUMP HOSE NO.1


    C101370E01
  1. Connect the oil reservoir to pump hose No.1 to the vane pump assembly with the clip.



4. ADD POWER STEERING FLUID


5. BLEED POWER STEERING FLUID



6. CHECK FOR POWER STEERING FLUID LEAKS


7. INSTALL ENGINE UNDER COVER NO.2


8. INSTALL ENGINE UNDER COVER NO.1