VANE PUMP (for 2KD-FTV) > INSPECTION |
| 1. INSPECT VANE PUMP SHAFT AND BUSHING IN FRONT VANE PUMP HOUSING |
![]() |
Using a micrometer and vernier calipers, measure the oil clearance.
| 2. INSPECT VANE PUMP ROTOR AND VANE PUMP PLATES |
![]() |
Using a micrometer, measure the thickness of the vane pump plates.
![]() |
Using a feeler gauge, measure the clearance between a side face of the vane pump rotor groove and the vane pump plates.
| 3. INSPECT FLOW CONTROL VALVE |
![]() |
Coat the flow control valve with power steering fluid and check that it falls smoothly into the flow control valve hole under its own weight
If it lacks smoothness, replace the vane pump assembly.
![]() |
Check the flow control valve for leakage. Close one of the holes and apply compressed air, 392 to 490 kPa (4 to 5 kgf/cm2, 57 to 71 psi), into the opposite side hole, and confirm that air does not come out from the end holes.
If air leaks, replace the vane pump assembly.
| 4. INSPECT FLOW CONTROL VALVE COMPRESSION SPRING |
![]() |
Using vernier calipers, measure the free length of the flow control valve compression spring.
| 5. INSPECT PRESSURE PORT UNION |
| 6. INSPECT TOTAL PRELOAD |
Check that the pump rotates smoothly without abnormal noise.
Temporarily install the service bolt.
![]() |
Using a torque wrench, check the rotating torque.