Home › STEERING › POWER STEERING › VANE PUMP (for 2KD-FTV)

VANE PUMP (for 2KD-FTV) > DISASSEMBLY

for Preparation Click here



1. FIX VANE PUMP ASSEMBLY


    G020894E01
  1. Using SST, hold the vane pump assembly in a vice.

    SST
    09630-00014   (09631-00132)



2. REMOVE SUCTION PORT UNION
  1. Remove the bolt and the suction port union.

  1. Remove the O-ring from the suction port union.



3. REMOVE FLOW CONTROL VALVE


    C101967E01
  1. Remove the pressure port union.

  1. Remove the O-ring from the pressure port union.

  1. Remove the flow control valve and the compression spring.



4. REMOVE REAR VANE PUMP HOUSING


    G021499
  1. Remove the 4 bolts and the rear vane pump housing.

  1. Remove the O-ring from the rear vane pump housing.



5. REMOVE VANE PUMP ROTOR
  1. Remove the 10 vane pump plates.

  1. Remove the vane pump rotor.



6. REMOVE VANE PUMP CAM RING


7. REMOVE FRONT VANE PUMP SIDE PLATE
  1. Remove the front vane pump side plate from the front vane pump housing.



    C101969
  1. Remove the O-ring from the front vane pump side plate.



    C101970
  1. Remove the O-ring from the front vane pump housing.



8. REMOVE VANE PUMP GEAR


    C101971E01
  1. Using a screwdriver, remove the vane pump housing snap ring No.1 from the front vane pump housing.

    HINT:
    Tape the screwdriver tip before use.

  1. Wrap the serration of the vane pump shaft with protective tape.



    C102430E01
  1. Using a press, remove the vane pump shaft from the front vane pump housing.

    NOTICE:
    Do not drop the vane pump shaft.

  1. Temporarily install the service bolt.

    Recommended service bolt:
    Thread diameter:
    10 mm (0.39 in.)
    Thread pitch:
    1.25 mm (0.0492 in.)
    Bolt length:
    50 mm (1.97 in.)



    C102431E01
  1. Using SST and a press, remove the vane pump gear from the vane pump shaft.

    SST
    09950-00020  



9. REMOVE VANE PUMP SHAFT BEARING


    C101974E01
  1. Using SST and a press, remove the vane pump shaft bearing from the vane pump shaft.

    SST
    09950-00020  



    C101975
  1. Using a snap ring expander, remove the vane pump shaft snap ring from the vane pump shaft.



10. REMOVE VANE PUMP HOUSING OIL SEAL


    C101976E01
  1. Using SST, remove the vane pump housing oil seal from the front vane pump housing.

    SST
    09319-60020  
    09527-10011