Home › STEERING › POWER STEERING › VANE PUMP (for 2TR-FE)

VANE PUMP (for 2TR-FE) > REMOVAL

for Preparation Click here



1. DRAIN POWER STEERING FLUID


2. REMOVE FAN AND GENERATOR V BELT


    A102135E01
  1. Use the hexagon-shaped part indicated by the arrow in the illustration to move the tensioner pulley downward and decrease the tension in the drive belt. Then remove the drive belt.

    NOTICE:
    When removing the drive belt, do not use the idle pulley's bolt.

    HINT:
    After removing the drive belt, move the tensioner upward to the maximum amount.



3. SEPARATE PRESSURE FEED TUBE ASSEMBLY


    C101366E01
  1. Remove the clip and the pressure feed tube assembly (return tube side).



    C101367E01
  1. Remove the union bolt and the pressure feed tube assembly (pressure feed tube side).

  1. Remove the gasket from the pressure feed tube assembly.



4. REMOVE VANE PUMP ASSEMBLY


    C101368E01
  1. Disconnect the oil pressure switch connector.



    C101369
  1. Remove the 2 bolts and the vane pump assembly.