Home › STEERING › POWER STEERING › STEERING TORQUE SHAFT

STEERING TORQUE SHAFT > INSTALLATION

for Preparation Click here



1. PLACE FRONT WHEELS FACING STRAIGHT AHEAD


2. INSTALL STEERING SLIDING YOKE SUB-ASSEMBLY


    C106145E01
  1. Align the matchmarks on the steering sliding yoke sub-assembly and the steering torque shaft assembly.

  1. Temporarily tighten the bolt.

    HINT:
    Do not torque the bolt.



3. INSTALL STEERING TORQUE SHAFT ASSEMBLY


    C106141E01
  1. Align the matchmarks on the steering torque shaft assembly and the steering bevel gear assembly.



    C106144
  1. Install the bolt.

    Torque:
    35 N*m{ 360 kgf*cm , 26 ft.*lbf }



    C106143E01
  1. Align the matchmarks on the steering torque shaft assembly and the power steering link assembly.



    C106142E01
  1. Install bolt (B) and tighten the 2 bolts.

    Torque:
    35 N*m{ 360 kgf*cm , 26 ft.*lbf }



4. INSTALL ENGINE UNDER COVER NO.1