Home › STEERING › POWER STEERING › STEERING BEVEL GEAR

STEERING BEVEL GEAR > REMOVAL

for Preparation Click here



1. PLACE FRONT WHEELS FACING STRAIGHT AHEAD


2. REMOVE STEERING COLUMN HOLE COVER


    C101359E01
  1. Remove 3 bolts and the steering column hole cover.



3. SEPARATE STEERING INTERMEDIATE SHAFT ASSEMBLY NO.2


    C106138
  1. Fix the steering wheel with the seat belt in order to prevent rotation.

    HINT:
    This operation is useful to prevent damage to the spiral cable.



    C106139E01
  1. Loosen bolt (A) and remove bolt (B), then slide the steering intermediate shaft assembly No.2.

    HINT:
    1. Do not remove bolt (A).
    2. Do not disconnect the steering intermediate shaft assembly No.2 from the steering intermediate shaft.



    C101361E01
  1. Put matchmarks on the steering intermediate shaft assembly No.2 and the steering intermediate shaft.

  1. Separate the steering intermediate shaft assembly No.2 from the steering intermediate shaft.



4. REMOVE STEERING COLUMN HOLE COVER SUB-ASSEMBLY NO.1


    C101362E01
  1. Remove the 4 bolts and the steering column hole cover sub-assembly No.1.



5. REMOVE STEERING INTERMEDIATE SHAFT


    C101363E01
  1. Put matchmarks on the steering intermediate shaft and the steering bevel gear assembly.

  1. Remove the bolt and the steering intermediate shaft from the steering bevel gear assembly.



6. REMOVE ENGINE UNDER COVER NO.1


7. REMOVE COOLING FAN ECU
(Click here for 2TR-FE, Click here for 2KD-FTV, Click here for 5L-E)


8. DISCONNECT OIL TUBE (for Automatic Transmission)
(Click here for 2TR-FE, Click here for 2KD-FTV)


9. REMOVE FAN SHROUD
(Click here for 2TR-FE, Click here for 2KD-FTV, Click here for 5L-E)


10. SEPARATE STEERING SLIDING YOKE SUB-ASSEMBLY


    C106140E01
  1. Loosen bolt (A) and remove bolt (B), then slide the steering sliding yoke sub-assembly.

    HINT:
    1. Do not remove bolt (A).
    2. Do not disconnect the steering sliding yoke sub-assembly from the steering bevel gear assembly.



    C106141E01
  1. Put matchmarks on the steering sliding yoke sub-assembly from the steering bevel gear assembly.

  1. Separate the steering sliding yoke sub-assembly from the steering bevel gear assembly.



11. REMOVE STEERING BEVEL GEAR HOUSING BRACKET


    C106160E01
  1. Remove the 3 bolts and the steering bevel gear housing bracket.



12. REMOVE STEERING BEVEL GEAR ASSEMBLY


    C106159E01
  1. Remove the 2 bolts and the steering bevel gear assembly.