POWER STEERING GEAR > INSPECTION |
| 1. INSPECT TIE ROD END SUB-ASSEMBLY LH |
Secure the tie rod end sub-assembly LH in a vise.
Install the nut to the stud bolt.
Flip the ball joint back and forth 5 times or more.
![]() |
Using a torque wrench, turn the nut continuously at a rate of 3 to 5 seconds per turn and take the torque reading on the 5th turn.
| 2. INSPECT TIE ROD END SUB-ASSEMBLY RH |
| 3. INSPECT POWER STEERING RACK |
![]() |
Using a dial indicator, check for runout of the steering rack.
Check for teeth wear of the steering rack.
Check the rack surface for wear and damage.
If there is any problem, replace the power steering rack.
| 4. INSPECT TOTAL PRELOAD |
Using a straight hexagon wrench 24 mm (0.94 in.), tighten the power steering rack guide spring cap.
Using a straight hexagon wrench 24 mm (0.94 in.), loosen the power steering rack guide spring cap.
Temporarily install the steering rack ends to prevent steering rack over stroke.
![]() |
Using SST, fully turn the power steering rack right and left 10 times to settle.
![]() |
Using a straight hexagon wrench 24 mm (0.94 in.), tighten the power steering rack guide spring cap in small amounts until the preload is within the specified range.
![]() |
Using SST, install the power steering rack guide spring cap nut.
![]() |
Using SST, inspect the total preload.