Home › STEERING › POWER STEERING › POWER STEERING GEAR

POWER STEERING GEAR > REMOVAL

for Preparation Click here



1. PLACE FRONT WHEELS FACING STRAIGHT AHEAD


2. FIX STEERING WHEEL POSITION


    C106138
  1. Fix the steering wheel with the seat belt in order to prevent rotation.

    HINT:
    This operation is useful to prevent damage to the spiral cable.



3. DRAIN POWER STEERING FLUID


4. REMOVE FRONT WHEELS


5. REMOVE ENGINE UNDER COVER NO.1


6. SEPARATE STEERING TORQUE SHAFT ASSEMBLY


    C106142E01
  1. Loosen bolt (A) and remove bolt (B), then slide the steering torque shaft assembly.

    HINT:
    1. Do not remove bolt (A).
    2. Do not disconnect the steering torque shaft assembly from the power steering link assembly.



    C106143E01
  1. Put matchmarks on the steering torque shaft assembly and the power steering link assembly.

  1. Separate the steering torque shaft assembly from the power steering link assembly.



7. SEPARATE TIE ROD END SUB-ASSEMBLY LH
  1. Remove the cotter pin and the nut.



    C101339E01
  1. Using SST, separate the tie rod end sub-assembly LH from the steering knuckle.

    SST
    09628-00011  

    NOTICE:
    1. Hang SST with a string, or other means, to prevent it from falling.
    2. Do not damage the front disc brake dust cover.
    3. Do not damage the ball joint dust cover.
    4. Do not damage the steering knuckle.



8. SEPARATE TIE ROD END SUB-ASSEMBLY RH

HINT:
Perform the same procedure as for the LH side.

SST
09628-00011  


9. SEPARATE PRESSURE FEED TUBE ASSEMBLY


    C106149
  1. Using pliers, grip the claws of the clip and separate the pressure feed tube assembly (return tube side) from the power steering link assembly.



    C106150E01
  1. Using SST, remove the steering gear outlet return tube.

    SST
    09023-12701  



    C106152E01
  1. Using SST, separate the pressure feed tube assembly (pressure tube side) from the power steering link assembly.



    C106148
  1. Remove the 2 bolts and the pressure feed tube clamp from the power steering link assembly.



10. REMOVE POWER STEERING LINK ASSEMBLY


    C106155
  1. Remove the 4 bolts and the power steering link assembly.



    C106154E03
  1. Put matchmarks on the steering rack housing bracket No.2, steering rack housing grommet No.2 and the power steering link assembly.

  1. Remove the steering rack housing bracket No.2, and the steering rack housing grommet No.2 from the power steering link assembly.