PROPELLER SHAFT ASSEMBLY (for Super Long Wheelbase) > INSTALLATION |
| 1. INSTALL PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY |
![]() |
Remove the SST from the extension housing.
Install the propeller with center bearing shaft assembly in the extension housing.
![]() |
Install the center support bearing assembly No.1, and temporarily tighten the 2 bolts.
![]() |
Align the matchmarks on the propeller shaft flange and differential flange.
Install the propeller shaft assy with the 4 nuts, 4 bolts and 4 washers.
![]() |
Check that the center line of the bracket is at right angles to the shaft axial direction.
![]() |
Adjust the center support bearing assembly No.1.
Tighten the 2 bolts.