Home › BODY › WINDSHIELD / WINDOWGLASS › POWER WINDOW CONTROL SYSTEM

POWER WINDOW CONTROL SYSTEM > Front Passenger Side Power Window Switch Power Source Circuit

for Preparation Click here


DESCRIPTION

This circuit supplies power to operate the power window switch.

WIRING DIAGRAM


B111213E01


INSPECTION PROCEDURE

1.CHECK WIRE HARNESS (POWER WINDOW SWITCH)


    B102538E02
  1. Disconnect the L6 (K6) connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    LHD Models:
    Tester Connection
    Condition
    Specified Condition
    K6-4 (B) - Body ground
    Always
    10 to 14 V
    RHD Models:
    Tester Connection
    Condition
    Specified Condition
    L6-4 (B) - Body ground
    Always
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE