Home › BRAKE › BRAKE CONTROL › ANTI-LOCK BRAKE SYSTEM

ANTI-LOCK BRAKE SYSTEM > TC and CG Terminal Circuit

for Preparation Click here


DESCRIPTION

DTC output mode is set by connecting terminals TC and CG of the DLC3.
The DTCs are displayed by the blinking pattern of the ABS warning light.

WIRING DIAGRAM


C109400E03

HINT:
When warning lights continue to blink, a ground short in the wiring of terminal TC of the DLC3 or an internal ground short in one or more ECU is suspected.


INSPECTION PROCEDURE

1.INSPECT DLC3 (BETWEEN DLC3 (TC) AND DLC3 (CG))


    C052361E48
  1. Turn the ignition switch to the ON position.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Specified Condition
    H23-13 (TC) - H23-4 (CG)
    10 to 14 V



NG
Go to step 3
OK


2.CHECK HARNESS AND CONNECTOR (BETWEEN SKID CONTROL ECU AND DLC3 (TC))


    C111163E01
  1. Turn the ignition switch off.

  1. Disconnect the skid control ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Specified Condition
    B19-16 (TC) - H23-13 (TC)
    Below 1 Ω
    B19-16 (TC) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE BRAKE ACTUATOR ASSEMBLY 

3.CHECK HARNESS AND CONNECTOR (BETWEEN DLC3 (CG) AND BODY GROUND)


    C052361E51
  1. Turn the ignition switch off.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Specified Condition
    H23-4 (CG) - Body ground
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.CHECK HARNESS AND CONNECTOR (BETWEEN SKID CONTROL ECU AND DLC3 (TC))


    C111163E01
  1. Disconnect the skid control ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Specified Condition
    B19-16 (TC) - H23-13 (TC)
    Below 1 Ω
    B19-16 (TC) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE BRAKE ACTUATOR ASSEMBLY