Home › BRAKE › BRAKE CONTROL › ANTI-LOCK BRAKE SYSTEM

ANTI-LOCK BRAKE SYSTEM > TERMINALS OF ECU

for Preparation Click here



TERMINALS OF ECU

C111164E01


Symbols (Terminal No.)
Terminal Description
+BS (1)
Power supply for solenoid
GND1 (2)
Skid control ECU ground
FL- (8)
Front left wheel speed sensor output
FL+ (9)
Front left wheel speed sensor input
STP (10)
Stop light switch input
RL+ (11)
Rear left wheel speed sensor input
RL- (12)
Rear left wheel speed sensor output
WA (13)
ABS warning light output
D/G (14)
Diagnosis tester communication line
TS (15)
Sensor check switch input
TC (16)
Diagnosis switch input
PKB (18)
Parking brake switch input
+BM (23)
Power supply for motor
GND2 (24)
Skid control ECU ground
IG1 (25)
ECU power supply
FR- (30)
Front right wheel speed sensor output
FR+ (31)
Front right wheel speed sensor input
RR+ (33)
Rear right wheel speed sensor input
RR- (34)
Rear right wheel speed sensor output

TERMINAL INSPECTION


  1. Disconnect the connector and measure the voltage or resistance on the wire harness side.


    C111153E02

    HINT:
    Voltage cannot be measured with the connector connected to the skid control ECU as the connector is watertight.


    Symbols (Terminal No.)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    +BS (B19-1) - Body ground
    W-R - Body ground
    Power supply for solenoid (Front battery)
    Always
    10 to 14 V
    GND1 (B19-2) - Body ground
    W-B - Body ground
    Skid control ECU ground
    Always
    Below 1 Ω
    STP (B19-10) - Body ground
    G-W - Body ground
    Stop light switch input
    Stop light switch ON → OFF (Brake pedal depressed → released)
    8 to 16 V → Below 1.5 V
    PKB (B19-18) - Body ground
    B - Body ground
    Parking brake switch input
    Ignition switch ON, parking brake switch ON → OFF
    Below 1.5 V → 10 to 14 V
    +BM (B19-23) - Body ground
    W - Body ground
    Power supply for motor (Front battery)
    Always
    10 to 14 V
    GND2 (B19-24) - Body ground
    W-B - Body ground
    Skid control ECU ground
    Always
    Below 1 Ω
    IG1 (B19-25) - Body ground
    B-R - Body ground
    ECU power supply
    Ignition switch OFF → ON
    Below 1 V → 10 to 14 V