Home › BRAKE › BRAKE CONTROL › ANTI-LOCK BRAKE SYSTEM

ANTI-LOCK BRAKE SYSTEM > DATA LIST / ACTIVE TEST

for Preparation Click here



DATA LIST
  1. While the intelligent tester is connected to the DLC3 with the ignition switch in the ON position, the ABS data list can be displayed. Follow the prompts on the tester screen to access the DATA LIST.

    Item (Display)
    Measurement Item / Range (Display)
    Normal Condition
    Diagnostic Note
    ABS Motor Relay
    ABS motor relay / ON or OFF
    ON: During pump motor operation
    OFF: No pump motor operation
    -
    Solenoid Relay
    Solenoid relay / ON or OFF
    ON: Solenoid relay ON
    OFF: Solenoid relay OFF
    -
    Stop Light SW
    Stop light switch / ON or OFF
    ON: Brake pedal depressed
    OFF: Brake pedal released
    -
    Parking Brake SW
    Parking brake switch / ON or OFF
    ON: Parking brake applied
    OFF: Parking brake released
    -
    FR Wheel ABS Control
    ABS operation (FR) / BEFORE or OPERATE
    BEFORE: No ABS operation (FR)
    OPERATE: During ABS operation (FR)
    -
    FL Wheel ABS Control
    ABS operation (FL) / BEFORE or OPERATE
    BEFORE: No ABS operation (FL)
    OPERATE: During ABS operation (FL)
    -
    RR Wheel ABS Control
    ABS operation (RR) / BEFORE or OPERATE
    BEFORE: No ABS operation (RR)
    OPERATE: During ABS operation (RR)
    -
    RL Wheel ABS Control
    ABS operation (RL ) / BEFORE or OPERATE
    BEFORE: No ABS operation (RL)
    OPERATE: During ABS operation (RL)
    -
    FR Wheel Speed
    Wheel speed sensor (FR) reading / min.: 0 mph (0 km/h), max.: 202 mph (326 km/h)
    Actual wheel speed
    Similar speed as indicated on speedometer
    FL Wheel Speed
    Wheel speed sensor (FL) reading / min.: 0 mph (0 km/h), max.: 202 mph (326 km/h)
    Actual wheel speed
    Similar speed as indicated on speedometer
    RR Wheel Speed
    Wheel speed sensor (RR) reading / min.: 0 mph (0 km/h), max.: 202 mph (326 km/h)
    Actual wheel speed
    Similar speed as indicated on speedometer
    RL Wheel Speed
    Wheel speed sensor (RL) reading / min.: 0 mph (0 km/h), max.: 202 mph (326 km/h)
    Actual wheel speed
    Similar speed as indicated on speedometer
    ECU IG Power Voltage
    ECU IG Power supply voltage / TOO LOW/NORMAL
    TOO LOW: 9.5 V or less
    NORMAL: 9.5 to 14.0 V
    -
    Solenoid (SFRR)
    ABS solenoid (SFRR) / ON or OFF
    ON: Operates
    -
    Solenoid (SFRH)
    ABS solenoid (SFRH) / ON or OFF
    ON: Operates
    -
    Solenoid (SFLR)
    ABS solenoid (SFLR) / ON or OFF
    ON: Operates
    -
    Solenoid (SFLH)
    ABS solenoid (SFLH) / ON or OFF
    ON: Operates
    -
    Solenoid (SRRR)
    ABS solenoid (SRRR) / ON or OFF
    ON: Operates
    -
    Solenoid (SRRH)
    ABS solenoid (SRRH) / ON or OFF
    ON: Operates
    -
    Vehicle Speed
    Vehicle speed reading / min.: 0 mph (0 km/h), max.: 202 mph (326 km/h)
    Actual vehicle speed
    Speed indicated on speedometer
    Test Mode
    Test mode operation / NORMAL or TEST
    NORMAL: Normal mode
    TEST: During test mode
    -
    Number of DTC
    Number of DTC recorded / min.: 0, max.: 255
    -
    -
    FR Speed Open
    Speed sensor open detection (FR) / OPN DET or NORMAL
    OPN DET: Momentary interruption
    NORMAL: Normal
    -
    FL Speed Open
    Speed sensor open detection (FL) / OPN DET or NORMAL
    OPN DET: Momentary interruption
    NORMAL: Normal
    -
    RR Speed Open
    Speed sensor open detection (RR) / OPN DET or NORMAL
    OPN DET: Momentary interruption
    NORMAL: Normal
    -
    RL Speed Open
    Speed sensor open detection (RL) / OPN DET or NORMAL
    OPN DET: Momentary interruption
    NORMAL: Normal
    -


ACTIVE TEST

HINT:
Performing the ACTIVE TEST using the intelligent tester allows the relay, actuator, etc. to operate without removing any parts. Performing the ACTIVE TEST as the first step of troubleshooting is one of the methods to shorten labor time.
It is possible to display the DATA LIST during the ACTIVE TEST.

  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch to the ON position.

  3. According to the display on the tester, perform the ACTIVE TEST.

    HINT:
    The ignition switch must be turned to the ON position to proceed to the ACTIVE TEST using the intelligent tester.


    Item (Display)
    Vehicle Condition / Test Details
    Diagnostic Note
    ABS Solenoid (SFRR)
    Turns ABS solenoid (SFRR) ON / OFF
    Operating sound of solenoid (clicking sound) is heard
    ABS Solenoid (SFRH)
    Turns ABS solenoid (SFRH) ON / OFF
    Operating sound of solenoid (clicking sound) is heard
    ABS Solenoid (SFLR)
    urns ABS solenoid (SFLR) ON / OFF
    Operating sound of solenoid (clicking sound) is heard
    ABS Solenoid (SFLH)
    Turns ABS solenoid (SFLH) ON / OFF
    Operating sound of solenoid (clicking sound) is heard
    ABS Solenoid (SRRR)
    Turns ABS solenoid (SRRR) ON / OFF
    Operating sound of solenoid (clicking sound) is heard
    ABS Solenoid (SRRH)
    Turns ABS solenoid (SRRH) ON / OFF
    Operating sound of solenoid (clicking sound) is heard
    ABS Solenoid (SFRR and SFRH)
    Turns ABS solenoid (SFRR and SFRH) ON / OFF
    Operating sound of solenoid (clicking sound) is heard
    ABS Solenoid (SFLR and SFLH)
    Turns ABS solenoid (SFLR and SFLH) ON / OFF
    Operating sound of solenoid (clicking sound) is heard
    ABS Solenoid (SRRR and SRRH)
    Turns ABS solenoid (SRRR and SRRH) ON / OFF
    Operating sound of solenoid (clicking sound) is heard
    ABS Motor Relay
    Turns ABS motor relay ON / OFF
    Operating sound of motor is heard
    Solenoid Relay
    Turns ABS solenoid relay ON / OFF
    Operating sound of solenoid (clicking sound) is heard
    ABS Warning Light
    Turns ABS warning light ON / OFF
    Observe combination meter