DTC C1241/41 Low Battery Positive Voltage |
| DTC No. | DTC Detection Condition | Trouble Area |
| C1241/41 | When any of the following is detected:
|
|

| 1.INSPECT BATTERY |
Check the battery voltage.
|
| ||||
| OK | |
| 2.INSPECT FUSE (ECU-IG FUSE) |
![]() |
Remove the ECU-IG fuse from the instrument panel J/B.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Specified Condition |
| ECU-IG (7.5 A) fuse | Below 1 Ω (Continuity) |
|
| ||||
| OK | |
| 3.READ VALUE OF INTELLIGENT TESTER (IG1 POWER SUPPLY) |
Install the ECU-IG fuse.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to the ON position and turn the intelligent tester main switch on.
Start the engine.
Select the DATA LIST mode on the intelligent tester.
| Item (Display) | Measurement Item / Range (Display) | Normal Condition | Diagnostic Note |
| ECU IG Power Voltage | ECU IG power supply voltage / TOO LOW/NORMAL | TOO LOW: 9.5 V or less NORMAL: 9.5 to 14.0 V | - |
Measure the voltage output from the ECU displayed on the intelligent tester.
|
| ||||
| OK | |
| 4.INSPECT SKID CONTROL ECU (IG TERMINAL VOLTAGE) |
![]() |
Disconnect the skid control ECU connector.
Turn the ignition switch to ON position.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Specified Condition |
| B19-25 (IG1) - Body ground | 10 to 14 V |
|
| ||||
| OK | |
| 5.INSPECT SKID CONTROL ECU (GND TERMINAL CONTINUITY) |
![]() |
Turn the ignition switch off.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Specified Condition |
| B19-2 (GND1) - Body ground | Below 1 Ω |
| B19-24 (GND2) - Body ground | Below 1 Ω |
|
| ||||
| OK | |
| 6.RECONFIRM DTC |
Clear the DTCs (Click here).
Check that the same DTC is recorded (Click here).
| Condition | Proceed to |
| DTC (C1241/41) is output | A |
| DTC (C1241/41) is not output (When troubleshooting in accordance with the DTC CHART) | B |
| DTC (C1241/41) is not output (When troubleshooting in accordance with the PROBLEM SYMPTOMS TABLE) | C |
|
| ||||
|
| ||||
| A | ||
| ||