Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › AIRBAG SYSTEM

AIRBAG SYSTEM > TC and CG Terminal Circuit

for Preparation Click here


DESCRIPTION

DTC output mode is set by connecting terminals TC and CG of the DLC3.
The DTCs are displayed by blinking the SRS warning light.

WIRING DIAGRAM


C113457E01


INSPECTION PROCEDURE

1.CHECK WIRE HARNESS (DLC3 - CENTER AIRBAG SENSOR ASSEMBLY)


    H040173E12
  1. Turn the ignition switch to the LOCK position.



    G027651E07
  1. Disconnect the connectors from the center airbag sensor assembly.

  1. Measure the resistance according to the value(s) in the table below.

    Resistance:
    Tester connection
    Condition
    Specified condition
    H23-13 (TC) -
    B4-15 (TC)
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE WIRE HARNESS (TC OF DLC3 - TC OF CENTER AIRBAG SENSOR ASSEMBLY)
OK


2.CHECK WIRE HARNESS (CG OF DLC3 - BODY GROUND)


    H040173E13
  1. Measure the resistance according to the value(s) in the table below.

    Resistance:
    Tester connection
    Condition
    Specified condition
    H23-4 (CG) -
    Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE WIRE HARNESS (CG OF DLC3 - BODY GROUND)
OK


3.CHECK WIRE HARNESS (TC OF CENTER AIRBAG SENSOR ASSEMBLY)


    G027651E07
  1. Measure the resistance according to the value(s) in the table below.

    Resistance:
    Tester connection
    Condition
    Specified condition
    B4-15 (TC) -
    Body ground
    Always
    1 MΩ or higher



NG
REPAIR OR REPLACE WIRE HARNESS OR EACH ECU
OK

REPLACE CENTER AIRBAG SENSOR ASSEMBLY