AIRBAG SYSTEM > DIAGNOSIS SYSTEM |
| CHECK DLC3 |
![]() |
The vehicle's ECM uses CAN and conforms to ISO 14230 and ISO 9141-2 for communication protocol. The terminal arrangement of the DLC3 complies with ISO 15031-3 and meets the ISO 14230 and ISO 9141-2 format.
| Symbols (Terminals No.) | Terminal Description | Condition | Specified condition |
| SIL (7) - SG (5) | Bus "+" line | During transmission | Pulse generation |
| CG (4) - Body ground | Chassis ground | Always | Below 1 Ω |
| SG (5) - Body ground | Signal ground | Always | Below 1 Ω |
| BAT (16) - Body ground | Battery positive | Always | 11 to 14 V |
| CANH (6) - CANL (14) | HIGH-level CAN bus line | Ignition switch OFF | 54 to 67 Ω |
| CANH (6) - Battery positive | HIGH-level CAN bus line | Ignition switch OFF | 1 MΩ or higher |
| CANH (6) - CG (4) | HIGH-level CAN bus line | Ignition switch OFF | 3 MΩ or higher |
| CANL (14) - Battery positive | LOW-level CAN bus line | Ignition switch OFF | 1 MΩ or higher |
| CANL (14) - CG (4) | LOW-level CAN bus line | Ignition switch OFF | 3 MΩ or higher |
| SYMPTOM SIMULATION |
![]() |
Vibration method: When vibration seems to be the major cause.
Slightly vibrate the part of the sensor considered to be the problem cause with your fingers and check whether the malfunction occurs.
Slightly shake the connector vertically and horizontally.
Slightly shake the wire harness vertically and horizontally.
The connector joint and fulcrum of the vibration are the major areas to be checked thoroughly.
| FUNCTION OF SRS WARNING LIGHT |
Primary check.
Turn the ignition switch to the LOCK position. Wait for at least 2 seconds, then turn the ignition switch to the ON position. The SRS warning light comes on for approximately 6 seconds and the diagnosis of the airbag system (including the seat belt pretensioners) is performed.
Constant check.
After the primary check, the center airbag sensor assembly constantly monitors the airbag system for trouble.
Review.
When the airbag system is normal:
The SRS warning light comes on only during the primary check period (for approximately 6 seconds after the ignition switch is turned to the ON position).
When the airbag system has trouble:
| SRS WARNING LIGHT CHECK |
![]() |
Turn the ignition switch to the ON position, and check that the SRS warning light comes on for approximately 6 seconds (primary check).
Check that the SRS warning light goes off approximately 6 seconds after the ignition switch is turned to the ON position (constant check).
| ACTIVATION PREVENTION MECHANISM |
FUNCTION OF ACTIVATION PREVENTION MECHANISM
An activation prevention mechanism is built into the connector (on the center airbag sensor assembly side) of the airbag system squib circuit to prevent accidental airbag activation.
This mechanism closes the circuit when the connector is disconnected by bringing the short spring into contact with the terminals and shutting off external electricity to prevent accidental airbag activation.
RELEASE METHOD OF ACTIVATION PREVENTION MECHANISM
To release the activation prevention mechanism, insert a piece of paper with the same thickness as the male terminal (approximately 0.5 mm (0.020 in.)) between the terminal and the short spring to break the connection.
Refer to the illustrations on the next 3 pages concerning connectors utilizing the activation prevention mechanism and its release method.


