Home › BODY ELECTRICAL › DOOR LOCK › WIRELESS DOOR LOCK CONTROL SYSTEM

WIRELESS DOOR LOCK CONTROL SYSTEM > Door Control Receiver Circuit

for Preparation Click here


DESCRIPTION

This door control receiver receives signals from the transmitter and sends these signals to the body ECU. The body ECU sends "LOCK" and "UNLOCK" signals to the door lock control motors.

WIRING DIAGRAM


E109136E03


INSPECTION PROCEDURE

1.INSPECT DOOR CONTROL RECEIVER (POWER SOURCE CIRCUIT)


    E107679E01
  1. Disconnect the door control receiver connector.

  1. Measure the voltage according to the value(s) in the table below.

    Voltage:
    Tester connection
    Condition
    Specified Condition
    Y2-1 (GND) - Y2-5 (+B)
    Always
    10 to 14 V



NG
Go to step 3
OK


2.CHECK HARNESS AND CONNECTOR (DOOR CONTROL RECEIVER - INSTRUMENT PANEL JUNCTION BLOCK)


    E107680E01
  1. Disconnect the instrument panel junction block connector.

  1. Measure the resistance according to the value(s) in the table below.

    Resistance:
    Tester connection
    Condition
    Specified Condition
    Y2-2 (RDA) - H7-7 (RDA)
    Always
    Below 1 Ω
    Y2-3 (PRG) - H7-6 (PRG)
    Always
    Below 1 Ω
    Y2-2 (RDA) - Body ground
    Always
    10 kΩ or higher
    Y2-3 (PRG) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE 

3.CHECK HARNESS AND CONNECTOR (DOOR CONTROL RECEIVER - BODY GYOUND)


    E107679E02
  1. Measure the resistance according to the value(s) in the table below.

    Resistance:
    Tester connection
    Condition
    Specified Condition
    Y2-1 (GND) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPAIR OR REPLACE HARNESS OR CONNECTOR (DOOR CONTROL RECEIVER - BATTERY)