LUBRICATION SYSTEM > ON-VEHICLE INSPECTION |
| 1. CHECK ENGINE OIL LEVEL |
Warm up the engine, stop the engine and wait for 5 minutes. The oil level should be between the low and full level marks of the dipstick.
If low, check for leakage and add oil up to the full level mark.
| 2. CHECK ENGINE OIL QUALITY |
![]() |
Check the oil for deterioration, water contamination, discoloring or thinning.
If the quality is visibly poor, replace the oil.
| 3. CHECK ENGINE OIL PRESSURE |
![]() |
Disconnect the oil pressure switch connector.
Remove the oil pressure switch.
Install the oil pressure gauge.
Warm up the engine.
Measure the oil pressure.
| Condition | Specified Condition |
| Idle | 29 kPa (0.3 kgf/cm2, 4.2 psi) or more |
| 3,000 rpm | 245 kPa (2.5 kgf/cm2, 36 psi) or more |
Remove the oil pressure gauge.
![]() |
Apply adhesive to 2 or 3 threads of the oil pressure switch.
Install the oil pressure switch.
Connect the oil pressure switch connector.
Start the engine and check for engine oil leaks.