Home › ENGINE ยท 2TR-FE › LUBRICATION › LUBRICATION SYSTEM

LUBRICATION SYSTEM > ON-VEHICLE INSPECTION

for Preparation Click here



1. CHECK ENGINE OIL LEVEL
  1. Warm up the engine, stop the engine and wait 5 minutes. The oil level should be between the dipstick's low and full level marks.
    If the oil level is low, check for leakage and add oil up to the full level mark.

    NOTICE:
    Do not fill with engine oil above the full level mark.



2. CHECK ENGINE OIL QUALITY


    A113813E01
  1. Check the oil for deterioration, water contamination, discoloring or thinning.

    Oil grade:
    20W-50 and 5W-40:
    API grade SJ or SL multigrade engine oil
    10W-30 and 5W-30:
    API grade SJ "Energy-Conserving", SL "Energy-Conserving" or ILSAC multigrade engine oil



3. CHECK OIL PRESSURE


    A102290E01
  1. Disconnect the oil pressure switch connector.

  1. Remove the oil pressure switch.

  1. Install the oil pressure gauge.

  1. Warm up the engine.

  1. Measure the oil pressure.

    Standard:

    Condition
    Specified Condition
    Idle
    29 kPa (0.3 kgf/cm2, 4.2 psi) or more
    3,000 rpm
    160 to 490 kPa (1.6 to 5.0 kgf/cm2, 23 to 71 psi) or more

    If the oil pressure is not as specified, check the oil pump (Click here)

  1. Remove the oil pressure gauge.



    G036762E02
  1. Apply adhesive to 2 or 3 threads of the oil pressure switch.

    Adhesive:
    Part No. 08833-0080, THREE BOND 1344, LOCTITE 242 or equivalent

  1. Install the oil pressure switch.

    Torque:
    15 N*m{ 153 kgf*cm , 11 ft.*lbf }

    NOTICE:
    Do not start the engine for at least 1 hour after installation of the switch.

  1. Connect the oil pressure switch connector.

  1. Start the engine and check for engine oil leaks.