Home › BODY ELECTRICAL › METER › METER / GAUGE SYSTEM

METER / GAUGE SYSTEM > Speedometer Malfunction

for Preparation Click here


WIRING DIAGRAM


E111213E01


INSPECTION PROCEDURE

1.INSPECT COMBINATION METER ASSEMBLY


    E109170E07
  1. Check the input signal waveform using an oscilloscope.

    1. Remove the combination meter assembly with the connector still connected.

    2. Connect the oscilloscope to the terminal SI (H20-15) and body ground.

    3. Start the engine.



    4. I043789E01
    5. Check the signal waveform according to the condition(s) in the table below.
      Item
      Condition
      Tool setting
      5 V/DIV., 10 ms/DIV.
      Vehicle condition
      Driving at approx. 20 km/h (12 mph)

      OK:
      The correct waveform appears as shown in the illustration.

      HINT:
      As vehicle speed increases, the cycle of the signal waveform narrows.



NG
Go to step 2
OK

REPLACE COMBINATION METER ASSEMBLY 

2.INSPECT SPEEDOMETER SENSOR


    E111212E01
  1. Disconnect the connector from the speedometer sensor.

  1. Measure the voltage according to the value(s) in the table below.
    Standard Voltage 
    Tester Connection
    Condition
    Specified Condition
    D38-1 (IG) - Body ground
    Turn the ignition switch OFF → ON
    Below 1 V → 10 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.CHECK HARNESS AND CONNECTOR (BETWEEN COMBINATION METER AND SPEEDOMETER SENSOR)


    E111214E01
  1. Disconnect H20 and D38 connectors.

  1. Measure the resistance according to the value(s) in the table below.

Standard Resistance 
Tester Connection
Condition
Specified Condition
SI (H20-15) - SI (D38-3)
Always
Below 1 Ω
E3 (H20-29) - E (D38-2)
Always
Below 1 Ω
SI (H20-15) - Body ground
Always
10 kΩ or higher


NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.INSPECT SPEEDOMETER SENSOR


    E111212E01
  1. Check voltage.

    1. Connect the positive lead (+) from the battery to terminal 1 and negative (-) lead to terminal 2.

    2. Connect the positive (+) lead from the tester to terminal 3 and the negative (-) lead to terminal 2.
      Standard Voltage 
      Tester Connection
      Condition
      Specified Condition
      IG (D38-1) - Body ground
      Ignition switch OFF → ON
      Below 1 V → 10 to 14 V

    3. Rotate the shaft.

    4. Check that there is voltage change from approximately 0 V to 11 V or more between terminals 2 and 3.

HINT:
The voltage should change 4 times for every revolution. If the result is not as specified, replace the sensor.



NG
REPLACE SPEEDOMETER SENSOR
OK

REPLACE COMBINATION METER ASSEMBLY