Home › BODY ELECTRICAL › METER › METER / GAUGE SYSTEM

METER / GAUGE SYSTEM > PRECAUTION

for Preparation Click here



1.REMOVAL AND INSTALLATION OF BATTERY TERMINAL


    D025080E03
  1. Before performing electronic work, disconnect the battery negative (-) terminal in order to prevent a short in the system.

  2. When disconnecting and reconnecting the battery cable, turn the ignition switch and lighting switches off and loosen the terminal nut completely. Perform these operations without prying on the terminal.

  3. When the battery terminal is removed, the memories of the clock, radio, DTCs, etc. are erased. So before removing the terminal, check and make a note of them.

    NOTICE:
    When disconnecting the battery negative (-) terminal, initialize the following system after the terminal is reconnected.
    System Name
    See Procedure
    Power Window Control System
    Click here