Home › BODY ELECTRICAL › METER › FUEL SENDER GAUGE ASSEMBLY

FUEL SENDER GAUGE ASSEMBLY > INSPECTION

for Preparation Click here



1. INSPECT FUEL SENDER GAUGE ASSEMBLY


    E111199E01
  1. Check that the float moves between F (top) and E (bottom) smoothly.

    OK:
    The float moves between F (top) and E (bottom) smoothly.

  1. Disconnect the h2 (*1)/h1 (*2) connector from the fuel sender gauge.



    I030899E03
  1. Measure the resistance according to the value(s) in the table below.
    Standard Resistance (Gasoline Engine) 
    Tester Connection
    Condition
    Specified Condition
    FUEL SENDER (h2-2) - EARTH (h2-3)
    F
    3.0 to 5.0 Ω
    FUEL SENDER (h2-2) - EARTH (h2-3)
    E
    107.5 to 112.5 Ω
    Tester Connection
    Coniditon
    Specified Condition
    FUEL SENDER (h1-2) - EARTH (h1-3)
    F
    3.0 to 5.0 Ω
    FUEL SENDER (h1-2) - EARTH (h1-3)
    E
    107.5 to 112.5 Ω
    *1: Gasoline engine
    *2: Diesel engine

    HINT:
    If the value is not as specified, replace the fuel sender gauge assemlby.