Home › BODY ELECTRICAL › METER › FUEL SEDIMENTER WARNING SWITCH

FUEL SEDIMENTER WARNING SWITCH > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT BRAKE MASTER CYLINDER RESERVOIR SUB-ASSEMBLY


    E111197E02
  1. Disconnect the B21 connector from the fuel sedimenter warning switch.

  1. Measure the resistance according to the value(s) in the table below.
    Standard Resistance 
    Tester Connection
    Condition
    Specified Conditon
    B21-1 - B21-2
    Float position: top
    Below 1 Ω
    B21-1 - B21-2
    Float position: bottom
    10 kΩ or higher

    HINT:
    If the value is not as specified, replace the fuel sedimenter warning switch.