Home › BODY ELECTRICAL › METER › BRAKE MASTER CYLINDER RESERVOIR

BRAKE MASTER CYLINDER RESERVOIR > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT BRAKE MASTER CYLINDER RESERVOIR
  1. Disconnect the connector from the brake master cylinder reservoir.

  1. Measure the resistance between the terminals after gradually draining brake fluid.

    Float position: top (Normal condition):
    10 kΩ or higher

    Float position: bottom (Abnormal condition):
    Below 1 Ω

    HINT:
    If the value is not as specified, replace the brake master cylinder reservoir.