CLOCK > ON-VEHICLE INSPECTION |
| 1. INSPECT CLOCK |
![]() |
Disconnect the H20 connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E1 (H20-7) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| B (H20-5) - Body ground | Always | 10 to 14 V |
| IG+ (H20-6) - Body ground | Ignition switch ON | 10 to 14 V |