Home › SUSPENSION & AXLE › AXLE › FRONT AXLE HUB

FRONT AXLE HUB > ON-VEHICLE INSPECTION

for Preparation Click here



1. REMOVE FRONT WHEEL


2. INSPECT FRONT AXLE HUB BEARING LOOSENESS


    C103109
  1. Using a dial indicator, check for looseness near the center of the axle hub.

    Maximum:
    0.07 mm (0.0028 in.)

    NOTICE:
    Ensure that the dial indicator is set at right angles to the measurement surface.

    If looseness exceeds the maximum, replace the bearing.



3. INSPECT FRONT AXLE HUB RUNOUT


    C103108
  1. Using a dial indicator, check for runout on the surface of the axle hub outside the hub bolt.

    Maximum:
    0.05 mm (0.0020 in.)

    NOTICE:
    Ensure that the dial indicator is set at right angles to the measurement surface.

    If runout exceeds the maximum, replace the axle hub.



4. INSTALL FRONT WHEEL

Torque:
100 N*m{ 1,020 kgf*cm , 74 ft.*lbf }