DTC C0273/13 Open in ABS Motor Relay Circuit |
DTC C0274/14 Short to B+ in ABS Motor Relay Circuit |
| DTC No. | DTC Detection Condition | Trouble Area |
| C0273/13 | With the IG1 terminal voltage 9.5 V or more, the motor relay contact is OFF for 0.2 seconds or more immediately after the motor relay is turned ON. |
|
| C0274/14 | The motor contact is ON for 4 seconds or more when the motor relay is OFF. |
|

| 1.INSPECT FUSE (ABS MTR FUSE) |
![]() |
Remove the ABS MTR fuse from the engine room R/B No.2.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Specified Condition |
| ABS MTR (40 A) fuse | Below 1 Ω (Continuity) |
|
| ||||
| OK | |
| 2.INSPECT SKID CONTROL ECU (+BM TERMINAL VOLTAGE) |
![]() |
Install the ABS MTR fuse.
Disconnect the skid control ECU connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| B19-23 (+BM) - Body ground | Always | 10 to 14 V |
|
| ||||
| OK | |
| 3.INSPECT SKID CONTROL ECU (GND TERMINAL CONTINUITY) |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Specified Condition |
| B19-2 (GND1) - Body ground | Below 1 Ω |
| B19-24 (GND2) - Body ground | Below 1 Ω |
|
| ||||
| OK | |
| 4.PERFORM ACTIVE TEST BY INTELLIGENT TESTER (ABS MOTOR RELAY) |
Reconnect the skid control ECU connector.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to the ON position and turn the intelligent tester main switch on.
Start the engine.
Select the ACTIVE TEST mode on the intelligent tester.
| Item (Display) | Vehicle Condition / Test Details | Diagnostic Note |
| ABS Motor Relay | Turns ABS motor relay ON / OFF | Operating sound of motor is heard |
Check operating sound of the ABS motor when operating it with the intelligent tester.
|
| ||||
| OK | |
| 5.RECONFIRM DTC |
Clear the DTCs (Click here).
Start the engine.
Drive the vehicle at the speed of 4 mph (6 km/h) or more.
Check that the same DTCs are recorded (Click here).
| Condition | Proceed to |
| DTCs (C0273/13 and C0274/14) are output | A |
| DTCs (C0273/13 and C0274/14) are not output | B |
|
| ||||
| A | ||
| ||