DTC C1251/51 Open in Pump Motor Circuit |
| DTC No. | DTC Detection Condition | Trouble Area |
| C1251/51 | When either of the following is detected during the initial check:
|
|
| 1.INSPECT SKID CONTROL ECU (GND TERMINAL CONTINUITY) |
![]() |
Disconnect the skid control ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Specified Condition |
| B19-2 (GND1) - Body ground | Below 1 Ω |
| B19-24 (GND2) - Body ground | Below 1 Ω |
|
| ||||
| OK | |
| 2.PERFORM ACTIVE TEST BY INTELLIGENT TESTER (ABS MOTOR RELAY) |
Reconnect the skid control ECU connector.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to the ON position and turn the intelligent tester main switch on.
Start the engine.
Select the ACTIVE TEST mode on the intelligent tester.
| Item (Display) | Vehicle Condition / Test Details | Diagnostic Note |
| ABS Motor Relay | Turns ABS motor relay ON / OFF | Operating sound of motor is heard |
Check operating sound of the ABS motor when operating it with the intelligent tester.
|
| ||||
| OK | |
| 3.RECONFIRM DTC |
Clear the DTCs (Click here).
Start the engine.
Drive the vehicle at the speed of 4 mph (6 km/h) or more.
Check that the same DTC is recorded (Click here).
| Condition | Proceed to |
| DTC (C1251/51) is output | A |
| DTC (C1251/51) not output | B |
|
| ||||
| A | ||
| ||