AIRBAG SYSTEM > SRS Warning Light does not Come ON |
| 1.CHECK BATTERY |
Measure the voltage of the battery.
|
| ||||
| OK | |
| 2.CHECK CONNECTORS |
Turn the ignition switch to the LOCK position.
Disconnect the negative (-) terminal cable from the battery, and wait for at least 90 seconds.
Check that the connectors are properly connected to the center airbag sensor assembly and the combination meter.
|
| ||||
| OK | |
| 3.CHECK WIRE HARNESS (SOURCE VOLTAGE OF COMBINATION METER) |
![]() |
Disconnect the connector from the combination meter.
Connect the negative (-) terminal cable to the battery, and wait for at least 2 seconds.
Turn the ignition switch to the ON position.
Measure the voltage according to the value(s) in the table below.
| Tester connection | Condition | Specified condition |
| H20-5 (B) - Body ground | Ignition switch ON | 10 to 14 V |
| H20-6 (IG+) - Body ground | Always | 10 to 14 V |
Turn the ignition switch to the LOCK position.
Measure the resistance according to the value(s) in the table below.
| Tester connection | Condition | Specified condition |
| H20-7 (E1) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | |
| 4.CHECK SRS WARNING LIGHT |
Turn the ignition switch to the LOCK position.
Disconnect the negative (-) terminal cable from the battery, and wait for at least 90 seconds.
Connect the connector to the combination meter.
Connect the negative (-) terminal cable to the battery, and wait for at least 2 seconds.
Turn the ignition switch to the ON position.
Check the SRS warning light condition.
|
| ||||
| OK | ||
| ||