Home › TRANSMISSION ยท A340E AUTOMATIC TRANSMISSION › SECOND COAST BRAKE

SECOND COAST BRAKE > REASSEMBLY

for Preparation Click here



1. INSPECT 2ND COAST BRAKE BAND ASSEMBLY


    D025701E02
  1. If the lining of the brake band is peeled off or discolored, or even if only a part of the printed numbers are corroded, replace the brake band.

    HINT:
    Before assembling the new band, soak it in ATF for at least 15 minutes.



2. INSTALL 2ND COAST BRAKE PISTON


AT07705
When the piston rod stroke is outside the standard value even if the brake band works normally, replace the rod with a new one.

HINT:
There are 2 different lengths for piston rod.

Piston rod length:
Number of grooves
Thickness mm (in.)
0
78.40 (3.087)
1
79.90 (3.146)



    D001299E02
  1. Install the washer plate, the compression spring and the piston to the piston rod.



    AT05260
  1. Firmly hold down the piston, then compress the compression spring.

  1. Using needle nose pliers, install the E-ring.



3. INSTALL 2ND COAST BRAKE PISTON OIL SEAL RING


    AT05419
  1. Coat the oil seal ring with ATF.

  1. Install the oil seal ring to the piston groove, then snug it down by squeezing its ends together.

    NOTICE:
    Do not over-spread the ring ends.