Home › TRANSMISSION ยท A340E AUTOMATIC TRANSMISSION › OVERDRIVE BRAKE

OVERDRIVE BRAKE > INSPECTION

for Preparation Click here



1. INSPECT PISTON OPERATION OF OVERDRIVE BRAKE


    AT08451
  1. Place the O/D support assembly onto the direct clutch assembly.



    AT08149
  1. Apply compressed air (392 kPa, 4 kgf/cm2, 57 psi) into the oil passage, and check that the O/D brake piston moves smoothly.



2. INSPECT OVERDRIVE BRAKE RETURN SPRING SUB-ASSEMBLY


    D001246
  1. Measure the free length of the spring together with the spring seat.

    Standard free length:
    17.03 mm (0.671 in.)



3. INSPECT OVERDRIVE BRAKE CLUTCH DISC


    AT06454E02
  1. Check if the sliding surface of the disc, the plate and the flange are worn or burnt. If necessary, replace them.

    HINT:
    1. If the lining of the disc is peeled off or discolored, or even if only a part of the printed numbers is corroded, replace all discs.
    2. Before assembling new discs, soak them in ATF for at least 15 minutes.



4. INSPECT PISTON OPERATION OF OVERDRIVE BRAKE


    AT08149
  1. Place the O/D support assembly onto the direct clutch assembly.

  1. Apply compressed air (392 kPa, 4 kgf/cm2, 57 psi) into the oil passage as shown, and be sure that the O/D brake piston moves smoothly.