Home › TRANSMISSION ยท A340E AUTOMATIC TRANSMISSION › OVERDRIVE BRAKE

OVERDRIVE BRAKE > DISASSEMBLY

for Preparation Click here



1. INSPECT PISTON OPERATION OF OVERDRIVE BRAKE


    AT08451
  1. Place the O/D support assembly onto the direct clutch assembly.



    AT08149
  1. Apply compressed air (392 kPa, 4 kgf/cm2, 57 psi) into the oil passage, and check that the O/D brake piston moves smoothly.



2. REMOVE OVERDRIVE BRAKE RETURN SPRING SUB-ASSEMBLY


    AT08444E02
  1. Place SST on the spring retainer, and compress the return spring with a press.

    SST
    09350-30020   (09350-07030)

  1. Remove the snap ring with a screwdriver.

  1. Remove the piston return spring.



3. INSPECT OVERDRIVE BRAKE RETURN SPRING SUB-ASSEMBLY


    D001246
  1. Measure the free length of the spring together with the spring seat.

    Standard free length:
    17.03 mm (0.671 in.)



4. REMOVE OVERDRIVE BRAKE PISTON


    D001432
  1. Place the O/D support onto the direct clutch assembly.

  1. Hold the O/D brake piston so that it does not slant, and apply compressed air (392 kPa, 4 kgf/cm2, 57 psi) into the passage to remove the O/D brake piston.

  1. Remove the O/D brake piston.



    D001336E02
  1. Remove the 2 O-rings.



5. REMOVE OVERDRIVE CLUTCH DRUM OIL SEAL RING


    AT08160
  1. Remove the 2 oil seal rings.



    AT08158
  1. Remove the thrust washer from O/D support.



6. INSPECT OVERDRIVE BRAKE CLUTCH DISC


    AT06454E02
  1. Check if the sliding surface of the disc, the plate and the flange are worn or burnt. If necessary, replace them.

    HINT:
    1. If the lining of the disc is peeled off or discolored, or even if only a part of the printed numbers is corroded, replace all discs.
    2. Before assembling new discs, soak them in ATF for at least 15 minutes.