Home › TRANSMISSION ยท A340E AUTOMATIC TRANSMISSION › OVERDRIVE BRAKE

OVERDRIVE BRAKE > REASSEMBLY

for Preparation Click here



1. INSTALL OVERDRIVE CLUTCH DRUM OIL SEAL RING


    AT08151
  1. Coat the 2 oil seal rings with ATF.

  1. Squeeze the ends of the 2 oil seal rings together, and then install them to the starter shaft groove.

    NOTICE:
    Do not spread the ring ends more than necessary.

    HINT:
    After installing the oil seal rings, check that they rotate smoothly.



    AT08158
  1. Coat the thrust washer with petroleum jelly, and install it into the O/D support.

    HINT:
    Make sure that the lugs shapes fit into the holes on the O/D support.



2. INSTALL OVERDRIVE BRAKE PISTON


    D001336E02
  1. Coat 2 new O-rings with ATF, and install them in the O/D brake piston.



    AT01979
  1. Being careful not to damage the O-rings, and press in the brake piston into the O/D support with both hands.



3. INSTALL OVERDRIVE BRAKE RETURN SPRING SUB-ASSEMBLY


    AT01978
  1. Install the piston return spring.



    D001341E02
  1. Place SST on the spring retainer, and compress the return spring with a shop press.

    SST
    09350-30020   (09350-07030)



    D025625E02
  1. Install the snap ring with a screwdriver.

    NOTICE:
    Be sure the end gap of the snap ring is not aligned with the cutout portion of the O/D support.

    HINT:
    After assembling the O/D support assembly completely, align the position of the piston with the position shown in the illustration "A".
    Align the end gap of the snap ring as shown in the illustration "B".
    Make sure that the snap ring is not on the part of return spring to prevents the spring from coming off. Check this on 8 places.



4. INSPECT PISTON OPERATION OF OVERDRIVE BRAKE


    AT08149
  1. Place the O/D support assembly onto the direct clutch assembly.

  1. Apply compressed air (392 kPa, 4 kgf/cm2, 57 psi) into the oil passage as shown, and be sure that the O/D brake piston moves smoothly.