DIRECT CLUTCH > DISASSEMBLY |
| 1. INSPECT PACK CLEARANCE OF DIRECT CLUTCH |
![]() |
Place the direct clutch assembly onto the O/D support assembly.
![]() |
Using SST and a dial indicator, measure the direct clutch pack clearance while applying and releasing compressed air (186 to 206 kPa, 1.9 to 2.1 kgf/cm2, 27 to 30 psi).
| 2. REMOVE DIRECT CLUTCH FLANGE |
![]() |
Using a screwdriver, remove the snap ring from the direct clutch drum.
Remove the flange, the 4 plates and the 4 discs.
| 3. INSPECT DIRECT CLUTCH FLANGE |
![]() |
Check to see if the sliding surface of the disc, the plate and the flange are worn or burnt. If necessary, replace them.
| 4. REMOVE DIRECT CLUTCH RETURN SPRING SUB-ASSEMBLY |
![]() |
Place SST on the piston return spring and compress.
Using SST, remove the snap ring.
![]() |
Remove the return spring.
| 5. INSPECT DIRECT CLUTCH RETURN SPRING SUB-ASSEMBLY |
![]() |
Measure the free length of the spring together with the spring seat.
| 6. REMOVE DIRECT CLUTCH RETURN SPRING SUB-ASSEMBLY |
![]() |
Place the direct clutch drum onto the O/D support.
Hold the direct clutch piston, and apply compressed air (196 kPa, 2.0 kgf/cm2, 28.5 psi) to the O/D support to remove the direct clutch piston.
![]() |
Using a small screwdriver, remove the 2 O-rings from the piston.
| 7. INSPECT DIRECT CLUTCH PISTON SUB-ASSEMBLY |
![]() |
Check that the check ball is free by shaking the piston.
Check that the valve does not have leaks by applying low-pressure compressed air.
| 8. INSPECT DIRECT CLUTCH DRUM SUB-ASSEMBLY |
![]() |
Using a deal indicator, measure the inside diameter of the clutch drum bushing.