Home › TRANSMISSION ยท A340E AUTOMATIC TRANSMISSION › DIRECT CLUTCH

DIRECT CLUTCH > REASSEMBLY

for Preparation Click here



1. INSTALL DIRECT CLUTCH PISTON SUB-ASSEMBLY


    D001453E02
  1. Coat 2 new O-rings with ATF, and install them in the direct clutch piston.



    D001354
  1. Be careful not to damage the O-rings, and press in the direct clutch piston into the clutch drum with both hands.



2. INSTALL DIRECT CLUTCH RETURN SPRING SUB-ASSEMBLY


    D001349E02
  1. Install the return spring.



    D001348E03
  1. Place SST on the spring retainer, and compress the return spring with a press.

    SST
    09350-30020   (09350-07040)

  1. Using SST, install the snap ring.

    SST
    09350-30020   (09350-07070)

    NOTICE:
    Be sure the end gap of the snap ring is not aligned with the spring retainer claw.



3. INSTALL DIRECT CLUTCH FLANGE


    AT01640E02
  1. Install the cushion plate.

  1. Install the 4 plates and the 4 discs.

    Install in order:
    P = Plate, D = Disc
    P - D - P - D - P - D - P - D

  1. Install the flange with the flat end facing downward.



    D001346
  1. Using a screwdriver, install the snap ring.

    NOTICE:
    Be sure the end gap of the snap ring is not aligned with the cutout portion of the direct clutch drum.



4. INSPECT PACK CLEARANCE OF DIRECT CLUTCH


    AT08250
  1. Place the direct clutch assembly onto the O/D support assembly.



    D029739E01
  1. Using SST and a dial indicator, measure the direct clutch piston stroke while applying and releasing compressed air (392 kPa, 4.0 kgf/cm2, 57 psi).

    SST
    09350-30020   (09350-06120)

    Pack Clearance:
    0.40 to 0.70 mm (0.016 to 0.028 in.)

    If the pack clearance is less than the limit of piston stroke, parts may have been assembled incorrectly, so check and reassemble again.
    If the pack clearance is outside the standard, select another flange.

    HINT:
    There are 8 different flanges in thickness.

    Flange thickness:
    mm (in.)
    No.
    Thickness
    No.
    Thickness
    53
    3.3 (0.130)
    57
    3.7 (0.146)
    54
    3.4 (0.134)
    58
    3.8 (0.150)
    55
    3.5 (0.138)
    60
    4.0 (0.157)
    56
    3.6 (0.142)
    62
    4.2 (0.165)