Home › TRANSMISSION ยท A340E AUTOMATIC TRANSMISSION › REAR PLANETARY GEAR

REAR PLANETARY GEAR > DISASSEMBLY

for Preparation Click here



1. REMOVE REAR PLANETARY GEAR ASSEMBLY


    AT08197
  1. Remove the output shaft from the rear planetary gear.



2. REMOVE PLANETARY OUTPUT SHAFT OIL SEAL RING


    AT08198
  1. Remove the oil seal ring from the output shaft.



3. REMOVE REAR PLANETARY RING GEAR


    AT08199
  1. Remove the rear planetary gear from the rear planetary ring gear.



4. INSPECT ONE WAY CLUTCH NO.2


    AT08200E02
  1. Hold the planetary gear and turn the one-way clutch inner race. Check that the one-way clutch inner race can be turned freely counterclockwise and locked clockwise.



5. REMOVE ONE WAY CLUTCH NO.2


    AT08191
  1. Remove the one-way clutch inner race from the rear planetary gear.



    AT08192
  1. Using a screwdriver, remove the snap ring.



    AT08193
  1. Remove the No.2 one-way clutch with the retainers from rear planetary gear.



6. REMOVE PLANETARY CARRIER THRUST WASHER NO.2


    D028060
  1. Remove the thrust washer No.2 from the rear planetary gear.



7. REMOVE PLANETARY CARRIER THRUST WASHER NO.1


    D028061
  1. Remove the thrust washer No.1 from the rear planetary gear.



8. REMOVE REAR PLANETARY FLANGE THRUST NEEDLE ROLLER BEARING


    AT08437
  1. Remove the 2 races and the bearing from the rear planetary ring gear.



9. REMOVE REAR PLANETARY RING GEAR FLANGE


    AT08206
  1. Using a screwdriver, remove the snap ring.



    AT08207
  1. Remove the ring gear flange.



10. INSPECT PLANETARY PINION GEAR THRUST CLEARANCE


    AT04459
  1. Using a feeler gauge, measure the planetary pinion gear thrust clearance.

    Standard clearance:
    0.20 to 0.60 mm (0.0079 to 0.0236 in.)

    Maximum clearance:
    0.65 mm (0.0256 in.)

    If the clearance is greater than the maximum, replace the planetary gear assembly.