OIL PUMP > INSPECTION |
| 1. INSPECT FRONT OIL PUMP BODY SUB-ASSEMBLY |
![]() |
Using a dial indicator, measure the inside diameter of the oil pump body bushing.
| 2. INSPECT STATOR SHAFT ASSEMBLY |
![]() |
Using a dial indicator, measure the inside diameter of the stator shaft bushing.
| 3. INSPECT CLEARANCE OF OIL PUMP ASSEMBLY |
![]() |
Using a feeler gauge, measure the clearance.
![]() |
Using a feeler gauge, measure the clearance between the driven gear teeth and the crescent shaped part of the pump body.
![]() |
Using a steel straight edge and a feeler gauge, measure the side clearance of both gears.
There are 5 different thickness for drive and driven gears.
| Mark | Thickness |
| F | 10.690 to 10.699 (0.4209 to 0.4212) |
| G | 10.700 to 10.709 (0.4213 to 0.4216) |
| H | 10.710 to 10.720 (0.4217 to 0.4220) |
| J | 10.721 to 10.730 (0.4221 to 0.4224) |
| K | 10.731 to 10.740 (0.4225 to 0.4228) |
| 4. INSPECT OIL PUMP DRIVE GEAR ROTATION |
![]() |
Make sure the drive gear rotates smoothly.
Remove the oil pump assembly from the torque converter clutch.