Home › TRANSMISSION ยท A340E AUTOMATIC TRANSMISSION › OIL PUMP

OIL PUMP > REASSEMBLY

for Preparation Click here



1. INSTALL FRONT OIL PUMP OIL SEAL


    AT05154E01
  1. Remove the oil pump driven gear.

  1. Using SST and a hammer, install a new oil seal.

    SST
    09350-30020   (09351-32140)

    HINT:
    The oil seal end should be flush with the outer edge of the pump body.

  1. Coat the oil seal lip with MP grease.



2. FIX FRONT OIL PUMP BODY SUB-ASSEMBLY


3. INSTALL FRONT OIL PUMP DRIVEN GEAR


    D025800
  1. Coat the driven gear with ATF.

  1. Install the driven gear to the oil pump body.



4. INSTALL FRONT OIL PUMP DRIVE GEAR


    D025799
  1. Coat the drive gear with ATF.

  1. Install the drive gear to the oil pump body.



5. INSTALL STATOR SHAFT ASSEMBLY


    AT08410
  1. Align the stator shaft with each bolt hole.

  1. Install the 13 bolts.

    Torque:
    10 N*m{ 100 kgf*cm , 7 ft.*lbf }



6. INSTALL STATOR SHAFT THRUST BEARING RACE


    AT08670
  1. Coat the thrust bearing race with petroleum jelly.

  1. Align the tap of the bearing race with the hollow of the pump body.



7. INSTALL CLUTCH DRUM OIL SEAL RING


    AT08409
  1. Coat the 2 oil seal rings with ATF.

  1. Squeeze the ends of the 2 oil seal rings together with the wrap distance 8 mm (0.31 in.) or less, and then install them to the starter shaft groove.

    NOTICE:
    Do not over-spread the ring ends.

    HINT:
    After installing the oil seal rings, check that they rotate smoothly.



8. INSPECT OIL PUMP DRIVE GEAR ROTATION


    AT08408
  1. Make sure the drive gear rotates smoothly.

  1. Remove the oil pump assembly from the torque converter clutch.



9. INSTALL FRONT OIL PUMP BODY O-RING


    D025646
  1. Install the O-ring to the oil pump assembly.