Home › TRANSMISSION ยท A343E AUTOMATIC TRANSMISSION › SECOND COAST BRAKE

SECOND COAST BRAKE > REASSEMBLY

for Preparation Click here



1. INSTALL 2ND COAST BRAKE PISTON


    AT07705
  1. There are 2 different lengths for the piston rod.
    Piston rod length: 
    Number of grooves
    Thickness mm (in.)
    0
    78.40 (3.087)
    1
    79.90 (3.146)
    When the piston rod stroke is outside the standard value even if the brake band works normally, replace the rod with a new one.



    AT05206E01
  1. Install the retainer, the spring and the piston to the piston rod.



    AT05260
  1. Firmly hold down the piston, then compress the compression spring.

  1. Using needle-nose pliers, install the E-ring.



2. INSTALL 2ND COAST BRAKE PISTON OIL SEAL RING


    AT05419
  1. Coat the oil seal ring with ATF.

  1. Squeeze the ends of the oil seal ring together with the wrap distance 8 mm (0.31 in.) or less, and then install them to the starter shaft groove.

    NOTICE:
    Do not over-spread the ring ends.