OVERDRIVE BRAKE > INSPECTION |
| 1. INSPECT PISTON OPERATION OF OVERDRIVE BRAKE |
![]() |
Place the O/D support assembly onto the direct clutch assembly.
![]() |
Apply compressed air (392 kPa, 4.0 kgf/cm2, 57 psi) into the oil passage as shown, and check that the O/D brake piston moves smoothly.
| 2. INSPECT OVERDRIVE BRAKE RETURN SPRING SUB-ASSEMBLY |
![]() |
Measure the free length of the spring together with the spring seat.
| 3. INSPECT OVERDRIVE BRAKE CLUTCH DISC |
![]() |
Check if the sliding surfaces of the disc, the plate and the flange are worn or burnt. If necessary, replace them.