Home › TRANSMISSION ยท A343E AUTOMATIC TRANSMISSION › OVERDRIVE BRAKE

OVERDRIVE BRAKE > DISASSEMBLY

for Preparation Click here



1. INSPECT PISTON OPERATION OF OVERDRIVE BRAKE


    AT08451
  1. Place the O/D support assembly onto the direct clutch assembly.



    AT08149
  1. Apply compressed air (392 kPa, 4.0 kgf/cm2, 57 psi) into the oil passage as shown, and check that the O/D brake piston moves smoothly.



2. REMOVE OVERDRIVE BRAKE RETURN SPRING SUB-ASSEMBLY


    AT08158
  1. Remove thrust washer from O/D support.



    AT08444E02
  1. Place SST on the spring retainer, and compress the return spring with a press.

    SST
    09350-30020   (09350-07030)

    NOTICE:
    Stop compressing when the spring sheet is lowered to the place 1 to 2mm(0.039 to 0.078 in.) from the snap ring groove, preventing the spring sheet from being deformed.

  1. Using a screwdriver, remove the snap ring.

  1. Remove the return spring.



3. INSPECT OVERDRIVE BRAKE RETURN SPRING SUB-ASSEMBLY


    D001246
  1. Measure the free length of the spring together with the spring seat.

    Standard free length:
    17.03 mm (0.671 in.)



4. REMOVE OVERDRIVE BRAKE PISTON


    AT08249
  1. Place the O/D support onto the direct clutch assembly.



    AT08159
  1. Hold the O/D brake piston so that it does not slant, and apply compressed air into the passage to remove the O/D brake piston.

  1. Remove the O/D brake piston.

  1. Remove the 2 O-rings from the piston.



5. REMOVE OVERDRIVE CLUTCH DRUM OIL SEAL RING


    AT08160
  1. Remove the 2 O/D clutch drum oil seal rings.