Home › TRANSMISSION ยท A343E AUTOMATIC TRANSMISSION › OVERDRIVE BRAKE

OVERDRIVE BRAKE > REASSEMBLY

for Preparation Click here



1. INSTALL OVERDRIVE CLUTCH DRUM OIL SEAL RING


    AT08151
  1. Coat the 2 oil seal rings with ATF.

  1. Squeeze the ends of the 2 oil seal rings together, and then install them to the O/D support groove.

    NOTICE:
    Do not spread the ring ends more than necessary.

    HINT:
    After installing the oil seal rings, check that they rotate smoothly.



2. INSTALL OVERDRIVE BRAKE PISTON


    AT01979
  1. Coat 2 new O-rings with ATF, and install them on the O/D brake piston.

  1. Being careful not to damage the O-rings, and press in the brake piston into the O/D support with both hands.



3. INSTALL OVERDRIVE BRAKE RETURN SPRING SUB-ASSEMBLY


    AT01978
  1. Install the piston return spring.



    AT08152E01
  1. Place SST on the spring retainer, and compress the return spring with a press.

    SST
    09350-30020   (09350-07030)

    NOTICE:
    Stop compressing when the spring sheet is lowered to the place 1 to 2 mm (0.039 to 0.078 in.) from the snap ring groove, preventing the spring sheet from bearing deformed.

  1. Using a screwdriver, install the snap ring. Be sure the end gap of the snap ring is not aligned with the cutout portion of the O/D support.



    AT08158
  1. Coat the thrust washer with petroleum jelly, and install it onto the O/D support.

    HINT:
    Make sure that the lug shape fits into the hole on the O/D support.



4. INSPECT PISTON OPERATION OF OVERDRIVE BRAKE


    AT08451
  1. Place the O/D support assembly onto the direct clutch assembly.



    AT08149
  1. Apply compressed air (392 kPa, 4.0 kgf/cm2, 57 psi) into the oil passage as shown, and check that the O/D brake piston moves smoothly.