DIRECT CLUTCH > REASSEMBLY |
| 1. INSPECT DIRECT CLUTCH PISTON SUB-ASSEMBLY |
![]() |
Check that the check ball is free by shaking the piston.
Check that the valve does not have leaks by applying low-pressure compressed air.
| 2. INSPECT DIRECT CLUTCH DRUM SUB-ASSEMBLY |
![]() |
Using a dial indicator, measure the inside diameter of the clutch drum bushing.
| 3. INSTALL DIRECT CLUTCH PISTON SUB-ASSEMBLY |
![]() |
Coat 2 new O-rings with ATF, and install them on the direct clutch piston.
Be careful not to damage the O-rings, and press the direct clutch piston into the clutch drum with both hands.
| 4. INSTALL DIRECT CLUTCH RETURN SPRING SUB-ASSEMBLY |
![]() |
Install the return spring.
Place SST on the spring retainer, and compress the return spring with a press.
Install the snap ring with SST. Be sure the end gap of the snap ring is not aligned with the spring retainer.
| 5. INSTALL DIRECT CLUTCH FLANGE |
Install the 3 plates and the discs.
![]() |
Install the flange with the flat end facing downward.
Using a screwdriver, install the snap ring.
| 6. INSPECT PISTON STROKE OF DIRECT CLUTCH |
![]() |
Place the direct clutch assembly onto the O/D support assembly.
![]() |
Using SST and a dial indicator, measure the direct clutch piston stroke while applying and releasing compressed air (392 to 785 kPa, 4.0 to 8.0 kgf/cm2, 57 to 114 psi).
| No. | Thickness | No. | Thickness |
| 53 | 3.3 (0.130) | 57 | 3.7 (0.146) |
| 54 | 3.4 (0.134) | 58 | 3.8 (0.150) |
| 55 | 3.5 (0.138) | 60 | 4.0 (0.157) |
| 56 | 3.6 (0.142) | 62 | 4.2 (0.165) |