Home › TRANSMISSION ยท A343E AUTOMATIC TRANSMISSION › OVERDRIVE DIRECT CLUTCH

OVERDRIVE DIRECT CLUTCH > REASSEMBLY

for Preparation Click here



1. INSTALL OVERDRIVE PLANETARY GEAR THRUST WASHER NO.3


    AT08148
  1. Install the thrust washer to the O/D planetary gear with the groove side facing upward.



2. INSTALL OVERDRIVE 1 WAY CLUTCH


    AT04451E03
  1. Install the 2 retainers to the one-way clutch.

  1. Install the one-way clutch into the outer race with the flange side of the one-way clutch facing upward.



    AT01638E02
  1. Install the O/D one-way clutch and outer race to the O/D planetary gear.



3. INSTALL OVERDRIVE RETAINING PLATE


    AT08146
  1. Install the retaining plate.



    AT08135
  1. Using a screwdriver, install the snap ring.



4. INSTALL OVERDRIVE PLANETARY RING GEAR FLANGE


    AT08134
  1. Install the ring gear flange.



    AT08133
  1. Using a screwdriver, install the snap ring.



5. INSTALL OVERDRIVE DIRECT CLUTCH PISTON SUB-ASSEMBLY


    AT08144
  1. Coat new O-rings with ATF, and install them on the O/D direct clutch piston.

  1. Being careful not to damage the O-rings, and press in the direct clutch piston into the clutch drum with both hands.



6. INSTALL OVERDRIVE CLUTCH RETURN SPRING SUB-ASSEMBLY


    AT08145
  1. Install the piston return spring to the piston.



    Z004660E02
  1. Place SST on the spring retainer, and compress the return spring with a press.

    SST
    09350-30020   (09350-07040)

    NOTICE:
    Stop compressing when the spring sheet is lowered to the place 1 to 2mm(0.039 to 0.078 in.) from the snap ring groove, preventing the spring sheet from being deformed.

  1. Using a screwdriver, install the snap ring. Be sure the end gap of the snap ring is not aligned with the spring retainer claw.



7. INSTALL OVERDRIVE DIRECT CLUTCH CLUTCH DISC


    AT01639E02
  1. Install the 2 plates and discs.

    Install in order:
    P = Plate D = Disc
    P - D - P - D



    AT08155
  1. Install the flange with the flat end facing downward.



    AT08131
  1. Using a screwdriver, install the snap ring.



8. INSPECT PISTON STROKE OF OVERDRIVE DIRECT CLUTCH


9. INSTALL OVERDRIVE DIRECT CLUTCH DRUM SUB-ASSEMBLY


    AT08139
  1. Align the flukes of the discs in the direct clutch.

  1. Install the direct clutch assembly onto the O/D planetary gear.



10. INSPECT OVERDRIVE 1 WAY CLUTCH


    AT08138E01
  1. Hold the O/D direct clutch drum, and turn the input shaft. Check that the input shaft can be turned freely clockwise and locked counterclockwise.